D200 GC Generator Set

Specifications

Full Specifications

Generator Set Specifications

Standby Rating
200 ekW

Frequency
60 Hz

Emissions/Fuel Strategy
U.S. EPA Tier 3 Certified

Voltage
208 to 600 Volts

Speed
1800 rpm

Duty Cycle
Standby

Engine Specifications

Engine Model
C7.1 I-6, 4-Cycle Diesel

Bore
4.1 in

Stroke
5.31 in

Displacement
428 in³

Compression Ratio
16.7:1

Aspiration
Turbocharged, Air to Air Aftercooled

Fuel System
Electronic, Common Rail

Governor Type
ADEM™A4

Generator Set Dimensions

Length - Maximum
103.7 in

Width - Maximum
51.2 in

Height - Maximum
58.7 in

Dry Weight - Genset (maximum)
3917 lb

Equipment

Standard Equipment

Air Inlet System

• Air cleaner; light duty with disposable element

Control Panels

• GCCP 1.2 Control panel

Cooling System

• Coolant drain line with valves
• Radiator and cooling fan with guards
• Caterpillar extended life coolant
• Fan drive, battery charging alternator drive

Generator and Generator Attachments

• Segregated low voltage (AC/DC) wiring panel
• Voltage regulator (single phase sensing)
• Circuit breaker, IEC, 3 pole, mounted in tower panel
• Tower panel, IP22, bottom cable entry
• 12 Leads
• IP23 Protection

Exhaust System

• Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose

Fuel System

• Standard open set fuel tank/base supplied
• Base, formed steel with single wall integral 24-hour fuel tank

Lube System

• Oil drain line with valve
• Lubricating oil

Mounting System

• Captive linear vibration isolators between base and engine-generator
• Includes lifting provision and drag points
• Termination points for coolant and lube oil drain lines

Starting / Charging System

• 24V battery with rack and cables

Governing System

• Mechanical and electrical governing system - model dependent

General

• Engine and alternator pre-paint, Caterpillar yellow

Optional Equipment

Alternator System

• Quatrature droop king
• Permanent magnet excitation (PMG)
• R Frame auxiliary winding: R2273L4 SE aux alt 07, aux alt 08 and aux alt 10
• Alternator removal
• Anti-condensation heater
• 3 Phase sensing
• Optional LC Frame alternator with coastal insulation protection

Circuit breakers

• Padlockable breaker device
• 4 Pole 250A, 400A and 630A Circuit breakers

Control Panel Options

• Earth leakage (2 wire only)
• Panel mounted audible alarm
• Speed adjust potentiometer
• Overload shutdown via breaker
• Emergency stop with key
• Earth fault (2 wire only)
• Control panel heater
• Battery charger
• Speed adjust contacts
• Volt free contacts

Control System

• Volt free contacts for generator set running
• GCCP 1.2
• Volt free contacts for common alarm
• Static battery charger

Cooling System

• Low coolant temperature
• Coolant heater
• Low coolant level shutdown

Enclosures

• Sound attenuated level 2 enclosure

Mounting Options

• Silencer installation kit
• Battery removal
• Electronic governor
• Industrial silencer removal
• Residential silencer

Fuel Systems

• Open set narrow tankbase
• Low fuel level shutdown
• Low fuel level alarm
• Compact skidbase for open sets
• DEFRA bunded fuel tank
• High fuel level alarm
• Skidbase for CALG enclosure sets

Test Reports

• PGS Test report @ 1.0 power factor
• PGS Test report @ 0.8 power factor

General

• Stone guards/radiator trans flange

Global Certifications

• Certification for CIS

Power Termination

• Circuit breaker, IEC, 4 pole

Accessories / Miscellaneous

• Packing case - canopied set
• Packing case - compact set

Resources

Electric Power Ratings Guide

D200 GC, C7.1, 60 Hz, 200 ekW, EPA Tier III Compliant Spec Sheet

Cat® GC Generator Set Brochure for North America